Beiträge von Soulchef
-
-
Ich gehe sogar so weit zu "behaupten" irgendwo in einer Schublade bei Suzuki in Japan liegt ein Dokument, wo mittlerweile genau drauf steht was diese Motoren für eine Problem haben!
There can be several different causes that can bring the engine out of normal behaviour ("low boost") and can be "fixed".
Unfortunately there is no easy solution for everyone, or the car/engine doesn't have the same power/characteristics as before, after the "fix" is applied.
I also think they know where the problem is ( it's been almost 4 years since the first report?), but that would probably then mean a new engine for everyone with that problem.
-
I think these are the torque specs although i'm not sure if there is enough space to squeeze the torque wrench.

-
16" @ 205/50 R16 is possible ... if you need more sidewalls?
Der Inhalt kann nicht angezeigt werden, da er nicht mehr verfügbar ist. -
Hallo
Here is the video: click
I think the original NGK are already with the anti-seize on the threads...
-
Einlass Dichtung 11216-77E00, 18X23.5X0.84
-
Soon you will no longer be allowed to change the cabin filter without approval?...:wacko:
-
How much did you lower the car - FA/HA?
-
-
@SVENS_S Check out posts by derkEy
-
Does anyone happen to have an log file (from obd scanner), e.g. that part during the transition when everything is normal and after the boost/power starts to drop?
-
Maybe this will help?
-disconnect the negative terminal of the battery for 10 minutes.
-then after 10 minutes attach the battery terminals.
-press the ignition twice without touching the pedals and wait 1 minute (don't start the engine).
-then turn it off and wait 1 minute.
-then start the engine and let it run for 10 minutes.
-
-
Da müssen die Suzuki Entwicklungsingenieure ran. Wo sitzen die, in Japan?
They probably came from Hungary, where the Suzuki factory is located.
-
Was ist das für ein Sensor, der Bosch 452? Ladedrucksensor?
0261 230 452,
0261 230 451
Yes, probably erasing fault codes only activates ECU re-learning.
To remove the second sensor, it is necessary to remove the filter box.
I don't know if it make any sense, because I think this has already been tried once before.
-
Good question. But ... who would know the answer. Maybe address directly to Bosch what you have found so far?
https://www.bosch-repair-service.com/en/category/engine-control-unit/
I think the problem is that you don't know what is being deleted in the background when you select the "delete" command.
Unless there is some low level debugger to bind it in between and then decrypt it somehow. But I don't know the how these things works, so maybe I'm writing nonsense.
-
So. Vor der Fahrt gelöscht alles gut, halbe Strecke Leistung weg und dann während der Fahrt gelöscht, sofort Leistung wieder da.
Integer overflow.
-
I remember that, yes, there was something about mixing fuel with diesel.
I read from someone in Japan where he replaced the 452 sensor with a new one, but then his car ran worse. Apparently, the shape of the sensor is also slightly different, or it is shaped differently in a certain part/area. Although it is the same catalog number.
-
In a previous thread, someone mentioned that they sent technicians from Japan. That was two years ago. But I don't know what they found out about these problems.
-
Mich würde interessieren wo der zweite Sensor sitzt. Vielleicht muss man sich den auch mal anschauen.
The second pressure sensor is behind the airbox filter:

Also there is like four sensors on the exhaust manifold??
